Chrysler 2005 Crossfire SRT6 Service Manual page 3610

23 - 62 CONVERTIBLE TOP
9620 MAIN CYLINDER TRAVEL SENSOR (BASE SIDE) +/- CIRCUIT OPEN/SHORT
TO GROUND (CONTINUED)
2.
Main Cylinder Travel Sensor (Base Side)
Turn the ignition off.
Disconnect the Power Top Travel Sensors harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
With the DRB III , select Sensor Display and monitor the MN CYL
TRVL SEN BSE.
Momentarily connect a fused jumper wire between the Main Cylinder
Travel Sensor (Base Side) (+) circuit and the Main Cylinder Travel
Sensor (Base Side) (-) circuit.
With the jumper connected, does the DRB III display MN CYL
TRVL SEN BSE above 100 Counts?
Yes >> Replace the Main Cylinder Travel Sensor.
Note: Travel Sensors are replaced as a set of four.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 3
3.
Main Cylinder Travel Sensor (Base Side) (+) circuit
Remove the jumper wire.
With the ignition on.
Measure the voltage of the Main Cylinder Travel Sensor (Base Side)
(+) circuit at the Power Top Travel Sensor harness connector.
Is the voltage above 10.0 volts?
Yes >> Go To 4
No >> Go To 6
ZH