Chrysler 2005 Crossfire SRT6 Service Manual page 3836

23 - 288 DOOR
7. Remove the plug on the underside of the door (2)
covering the bolt (3), loosen the bolt until the guide
rail can be moved.
Note: In the second detent stage of the door lock,
the edge of the window glass must disappear
completely below the rubber seal. If necessary, the
inclination of the window can be corrected by
loosening the bolts, and the longitudinal direction
of the window can be corrected by loosening the
bolt. In addition, the inclination of the window rel-
ative to the weatherstrip can be increased or
reduced by loosening the nut, the sliding jaw must
be moved for this purpose.
8. Adjust the window so that the upper glass edge
makes contact with the inner rubber sealing lip (1)
over the entire length when the door lock is in the
first catch position, then tighten bolts and nuts (3)
on the guide rail.
9. Tighten the bolts and nut if they were loosened.
10. Install the bolt plug.
Note: Grease the sliding jaws and guide rail as well as the window lift rail.
11. Check the window for ease of movement.
12. Install door foil on the door.
13. Install the door speaker.
14. Install the door trim panel on the front door. (Refer to 23 - BODY/DOOR - FRONT/TRIM PANEL -
INSTALLATION).
ZH