Chrysler 2005 Crossfire SRT6 Service Manual page 3546

22 - 60 TIRES/WHEELS - SERVICE INFORMATION
7. Squeeze the container and immerse the hose as deep as possible in the tire sealant through the valve bore in
the wheel.
8. Remove the sealant by sucking it out of the tire with the container until all of the TIREFIT sealant is removed.
This will generally remove 90% of the TIREFIT sealant.
9. Remove the tire from the wheel.
10. Clean the wheel making sure it is free of the TIREFIT sealant.
11. Install a new tire to the wheel.
12. Install the wheel and tire assembly to the vehicle. (Refer to 22 - TIRES/WHEELS/WHEELS - STANDARD
PROCEDURE).
CLEANING
Note: DO NOT use gasoline, mineral oil, oil-based solvent or a wire brush for cleaning.
Remove the protective coating on the tires before delivery of a vehicle. This coating may cause deterioration of the
tires.
To remove the protective coating, apply warm water and let it soak for a few minutes. Afterwards, scrub the coating
away with a soft bristle brush. Steam cleaning may also be used to remove the coating.
SPECIFICATIONS - TIRES
SPECIFICATIONS
DESCRIPTION
FRONT TIRES
REAR TIRES
WHEELS
DESCRIPTION
WHEELS
The rim size is located on the Vehicle Safety Certifi-
cation Label located on the driver's door shut face.
The size of the rim is determined by the drivetrain
package. Original equipment
designed for operation up to the specified maximum
vehicle capacity.
This vehicle has aluminum wheels. Every wheel has
raised sections between the rim flanges (1) and rim
drop well (3) called safety humps.
Initial inflation of the tire forces the bead over these
raised sections. In case of rapid loss of air pressure,
the raised sections help hold the tire on the wheel.
The wheel bolts are designed for specific applications.
All aluminum wheels have wheel bolts with an
enlarged head. This enlarged head is necessary to
ensure proper retention of the wheels. Do not use
replacement bolts with a different design or lesser
quality.
wheels/rims are
SPECIFICATION
225/40ZR18
255/35ZR19
ZH