Chrysler 2005 Crossfire SRT6 Service Manual page 4011

23 - 450 STATIONARY GLASS
CAUTION: Open a window before installing windshield. This will avoid pressurizing the passenger compart-
ment. If a door or liftgate is slammed before urethane is cured, water leaks can result.
Note: The windshield fence should be cleaned of old urethane bonding material. Support spacers should be
cleaned and properly installed on weld studs or repair screws at bottom of windshield opening.
1. Place replacement windshield (1) into windshield opening.
2. Position glass in the center of the opening against the support spacers (2).
Note: There are 4 support spacers — one in each
corner of the fence opening.
3. Mark the glass at the support spacers (2) with a
grease pencil or masking tape and ink pen to use
as a reference for installation.
4. Remove replacement windshield (1) from wind-
shield opening.
5. Position the windshield (1) inside up on a suitable
work surface with two padded, wood 10 cm by 10
cm by 50 cm (4 in. by 4 in. by 20 in.) blocks (2),
placed parallel 75 cm (2.5 ft.) apart.
ZH