Chrysler 2005 Crossfire SRT6 Service Manual page 3560

23 - 12 BODY - ELECTRICAL DIAGNOSTICS
REAR SPOILER LIMIT SWITCH SIGNAL (DOWN) CIRCUIT (CONTINUED)
2.
OPEN REAR SPOILER LIMIT SWITCH SIGNAL (DOWN) CIRCUIT
Turn the ignition off.
Measure the resistance of the Rear Spoiler Limit Switch Signal (Down)
circuit from the BCM C4 harness connector to the Rear Spoiler Limit
Switch harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 3
No >> Repair the Rear Spoiler Limit Switch Signal (Down) circuit
for an open.
Perform REAR SPOILER VERIFICATION TEST.
3.
OPEN REAR SPOILER LIMIT SWITCH GROUND CIRCUIT
With the ignition off.
Measure the resistance between ground and the Rear Spoiler Limit
Switch Ground circuit at the Rear Spoiler Limit Switch harness con-
nector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Body Control Module.(Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform REAR SPOILER VERIFICATION TEST.
No >> Repair the Rear Spoiler Limit Switch Ground circuit for an open.
Perform REAR SPOILER VERIFICATION TEST.
ZH