Chrysler 2005 Crossfire SRT6 Service Manual page 3895

23 - 334 HOOD
10. Tighten the bolts on the engine hood hinges.
Tighten to 10 N·m (88 in. lbs.).
Note: If necessary install a spacer below the top
section of engine hood latch. Raise/lower the
upper frame cross member.
11. Adjust the height of the stop bumper so that the
top edges of the front fenders are flush with the
hood.
12. Install the gas prop rod.
ADJUSTING IN LATERAL DIRECTION
1. Loosen the bolts (1) on the top section of hood
latch (2).
2. Adjust the gaps on the left and right of the hood.
3. Center the top section of hood latch (2) in the lat-
eral and longitudinal directions in relation to the
bottom section of the hood latch and then tighten
the bolts (2). Tighten to 8 N·m (70 in. lbs.).
4. Install the inner fender in the front fender.
Note: For this purpose close the hood, release and
ensure that hook is caught in upper frame cross
member.
5. Check the function of the safety hook.
6. Close the hood.
7. Check the locking function of the hood latch and
the safety hook.
GAP DIMENSIONS
Hood and front fender
Hood and front headlamps
Hood and radiator grille
Radiator grille and front headlamp
4.0 mm (±0.5 mm)
6.0 mm (+1/-0.5 mm)
7.0 mm (+1/-0.5 mm)
5.0 mm (+1/-0.5 mm)
ZH