Chrysler 2005 Crossfire SRT6 Service Manual page 3724

23 - 176 CONVERTIBLE TOP
9911/9912 TONNEAU COVER SWITCH SENSE CIRCUIT OPEN (CONTINUED)
3.
Open Tonneau Cover Switch Sense circuit
Turn the ignition off.
Remove fused jumper wire.
Disconnect the Power Top Control Module C1 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Tonneau Cover Switch Sense circuit
from the Tonneau Cover Switch harness connector to the Power Top
Control Module C1 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 4
No >> Repair the Tonneau Cover Switch Sense circuit for an
open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
4.
Open Tonneau Cover Switch Ground circuit
With the ignition off.
Measure the resistance between ground and the Tonneau Cover
Switch ground circuit.
Is the resistance below 5.0 ohms?
Yes >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Repair the Tonneau Cover Switch Ground circuit for an
open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL MODULES/
ZH