Chrysler 2005 Crossfire SRT6 Service Manual page 4279

24 - 150 PLUMBING
WARNING:
HIGH PRESSURES ARE PRODUCED IN THE REFRIGERANT SYSTEM WHEN THE AIR CONDITIONING COM-
PRESSOR IS OPERATING. EXTREME CARE MUST BE EXERCISED TO MAKE SURE THAT EACH OF THE
REFRIGERANT SYSTEM CONNECTIONS IS PRESSURE-TIGHT AND LEAK FREE. IT IS A GOOD PRACTICE
TO INSPECT ALL FLEXIBLE HOSE REFRIGERANT LINES AT LEAST ONCE A YEAR TO MAKE SURE THEY
ARE IN GOOD CONDITION AND PROPERLY ROUTED.
1. Install the suction line to the compressor. Tighten
the mounting bolt to 23 N·m (18 ft. lbs.).
2. Install the A/C compressor bolts (1).(Refer to 24 -
HEATING & AIR CONDITIONING/PLUMBING/A/C
COMPRESSOR - INSTALLATION).
3. Slide the suction line and the liquid line over the
expansion valve stud. Tighten the nut (1) to 10 N·m
(88 in. lbs.).
4. Connect the negative battery cable.
5. Evacuate the refrigerant system. (Refer to 24 -
HEATING & AIR CONDITIONING/PLUMBING -
STANDARD PROCEDURE).
6. Charge the refrigerant system. (Refer to 24 -
HEATING & AIR CONDITIONING/PLUMBING -
STANDARD PROCEDURE).
ZH