Chrysler 2005 Crossfire SRT6 Service Manual page 4320

ZH
5. Remove the EGR tube flange nut (2) at valve.
6. Remove the solenoid to valve mounting bolt (3).
7. Remove the valve to cylinder head mounting bolts
(1).
8. Clean the gasket surfaces. Discard the old gasket.
9. Clean the EGR passages as necessary.
INSTALLATION
1. Position new gasket between the valve and cylin-
der head.
2. Loosely install valve front bolt (1) to cylinder head,
do not tighten bolt.
3. Position solenoid to valve and loosely install sole-
noid (3) to valve bolt.
4. Loosely install valve rear bolt (2) to cylinder head,
do not tighten bolt.
5. Loosely install the EGR tube flange nut (2) to
valve.
6. Tighten the valve to cylinder head bolts (1) to 31
N·m (23 ft. lbs.).
7. Tighten the flange nut (2) to 11 N·m (95 in. lbs.).
8. Tighten the solenoid to valve bolt (3) to 11 N·m (95
in. lbs.).
EXHAUST GAS RECIRCULATION 25 - 27