Chrysler 2005 Crossfire SRT6 Service Manual page 3634

23 - 86 CONVERTIBLE TOP
9640 REAR BOW TRAVEL SENSOR (BASE SIDE) +/- CIRCUIT OPEN/SHORT TO GROUND (CONTINUED)
5.
Rear Bow Travel Sensor (Base Side) (-) Circuit Shorted to Ground
With the ignition off.
Measure the resistance between ground and the Rear Bow Travel
Sensor (Base Side) (-) circuit.
Is resistance below 100 kohms?
Yes >> Repair the Rear Bow Travel Sensor (Base Side) (-) circuit
for a short to ground.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
6.
Open Rear Bow Travel Sensor (Base Side) (+) Circuit
With the ignition on.
Measure the voltage of the Rear Bow Travel Sensor (Base Side) (+)
circuit by backprobing from the Power Top Control Module C1 harness
connector.
Is the voltage above 10.0 volts?
Yes >> Repair the Rear Bow Travel Sensor (Base Side) (+) circuit
for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 7
CONTROL MODULES/
ZH