Chrysler 2005 Crossfire SRT6 Service Manual page 3646

23 - 98 CONVERTIBLE TOP
9651 TONNEAU COVER CYLINDER TRAVEL SENSOR (-) CIRCUIT SHORT TO B(+) (CONTINUED)
• When Monitored: Continuous with the ignition on.
• Set Condition: When the Power Top Control Module senses a short to B(+) on the Tonneau Cover Cyl-
inder Travel Sensor (-) circuit.
TRAVEL SENSOR (-) CIRCUIT SHORT TO B(+)
POWER TOP CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
Tonneau Cover Cylinder Travel Sensor (-) Short to B(+)
Turn the ignition off.
Disconnect the Power Top Control Module C2 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Tonneau Cover Cylinder Travel Sensor (-)
circuit at the Power Top Control Module C2 harness connector.
Is the voltage above 1.0 volt?
Yes >> Repair the Tonneau Cover Cylinder Travel Sensor (-) cir-
cuit for a short to B(+).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
Possible Causes
CONTROL MODULES/
ZH