Chrysler 2005 Crossfire SRT6 Service Manual page 3563

ZH
REAR SPOILER DRIVER (UP) CIRCUIT (CONTINUED)
2.
REAR SPOILER DRIVER (UP) CIRCUIT SHORT TO B(+)
Turn the ignition on.
Measure the voltage of the Rear Spoiler Driver (Up) circuit at the Rear
Spoiler Motor harness connector.
Is the voltage above 1.0 volts?
Yes >> Repair the Rear Spoiler Driver (Up) circuit for a short to
B(+).
Perform REAR SPOILER VERIFICATION TEST.
No >> Go to 3
3.
REAR SPOILER DRIVER (UP) CIRCUIT SHORT TO GROUND
Turn the ignition off.
Measure the resistance between ground and the Rear Spoiler Driver
(Up) circuit at the Rear Spoiler Motor harness connector.
Is the resistance below 100k ohms?
Yes >> Repair the Rear Spoiler Driver (Up) circuit for a short to
ground.
Perform REAR SPOILER VERIFICATION TEST.
No >> Replace the Body Control Module.(Refer to 8 - ELECTRI-
CAL/ELECTRONIC CONTROL MODULES/BODY CON-
TROL/CENTRAL TIMER MODUL - REMOVAL).
Perform REAR SPOILER VERIFICATION TEST.
BODY - ELECTRICAL DIAGNOSTICS 23 - 15