Chrysler 2005 Crossfire SRT6 Service Manual page 3878

ZH
INSTALLATION - SPOILER MOTOR HARNESS
1. Connect the harness (6) to the spoiler motor (5).
2. Attach the harness connectors (3) to the spoiler
motor bracket (1).
NOTE: Be sure the microswitches are aligned
properly with the cams on the spoiler motor.
3. Position the microswitches (4) and install new
retainers.
4. Position the spoiler motor bracket and install the 4
nuts (2).
5. Connect the electrical connectors (3).
6. Install the lower liftgate trim panel (Refer to 23 -
BODY/DECKLID/HATCH/LIFTGATE/TAILGATE/
TRIM PANEL - INSTALLATION).
7. Connect the negative battery cable.
8. Operate the spoiler and check for proper operation.
INSTALLATION - DRIVESHAFT
NOTE: Only one side is shown. The procedure is the same for both sides.
1. Insert the driveshaft end through the hole in the mounting plate, then connect it to the spoiler transmission.
2. Position the spoiler wing frame (4) over the drive-
shaft end (3) and install the nuts (1).
3. Rotate the spoiler wing frame to access the roll pin
hole, and install the roll pin (2).
4. Rotate the spoiler frame to the full open position.
5. Install the spoiler motor (Refer to 23 - BODY/EX-
TERIOR/SPOILER - INSTALLATION).
6. Install the spoiler wing (Refer to 23 - BODY/EXTE-
RIOR/SPOILER - INSTALLATION).
2005 ZH Service Manual Publication No. 81-270-05036
EXTERIOR 23 - 318K
05ZH23-318K October, 2004