Chrysler 2005 Crossfire SRT6 Service Manual page 4314

ZH
train Control Module (PCM) purges the canister through the pulse-width modulated EVAP Purge Solenoid. The PCM
purges the canister at predetermined intervals and engine conditions.
REMOVAL
1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Remove the shield retaining nuts from splash shield.
4. Remove the splash shield.
5. Carefully disconnect the vapor/vacuum/vent hoses (2).
6. Slide the EVAP canister (4) to the left, off of mounting bracket.
7. Disconnect the charcoal canister shutoff valve harness connector (1).
8. Depress the locking tab (2) to release charcoal
canister shutoff valve (1).
9. While holding the lock tab (2) in release position,
turn charcoal canister shutoff valve (1) clockwise
and remove from EVAP canister.
10. Discard the old O-ring (3).
EVAPORATIVE EMISSIONS 25 - 21