Chrysler 2005 Crossfire SRT6 Service Manual page 3685

ZH
9841 HYDRAULIC SOLENOID S4 SUPPLY VOLTAGE CIRCUIT OPEN/SHORT TO B(+) (CONTINUED)
4.
Open Hydraulic Solenoid S4 Supply Voltage circuit
With the ignition off.
Disconnect the Hydraulic Solenoid S4 harness connector.
Measure the resistance of the Hydraulic Solenoid S4 Supply Voltage
circuit from the Power Top Control Module C2 harness connector to
the Hydraulic Solenoid S4 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the Hydraulic Solenoid S4 Supply Voltage circuit for
an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
5.
Open Hydraulic Solenoid S3/S4 Ground circuit
With the ignition off.
Measure the resistance of the Hydraulic Solenoid S3/S4 Ground circuit
from the Power Top Control Module C2 harness connector to the
Hydraulic Solenoid S4 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Power Top Hydraulic Assembly.(Refer to 23 -
BODY/CONVERTIBLE TOP/HYDRAULIC PUMP MOTOR
- REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Repair the Hydraulic Solenoid S3/S4 Ground circuit for an
open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONVERTIBLE TOP 23 - 137