Chrysler 2005 Crossfire SRT6 Service Manual page 4056

ZH
REMOVAL
REMOVAL - TONNEAU COVER CYLINDER
1. Disconnect the negative battery cable.
2. Remove the left side trunk trim panel.
Note: Do not disconnect the hydraulic lines from
the pump assembly.
3. Partially remove the hydraulic pump assembly
(Refer to 23 - BODY/CONVERTIBLE TOP/HY-
DRAULIC PUMP MOTOR - REMOVAL).
4. Remove the hydraulic line retainers and disconnect
the lines from the cylinder (1).
5. Remove the travel sensor from the cylinder (Refer
to 23 - BODY/CONVERTIBLE TOP/HYDRAULIC
CYLINDER - REMOVAL).
6. Remove the cylinder lower retainer (3) and remove
the cylinder (1) from the pump bracket (2).
REMOVAL - MAIN CYLINDER
Note: Left side shown, right side similar.
1. Disconnect the negative battery cable.
2. Manually raise tonneau cover and support (Refer to
23 - BODY/CONVERTIBLE TOP - STANDARD
PROCEDURE).
3. Remove the upper and lower cylinder retainers (2).
4. Remove the main cylinder (1) from the top frame
assembly to gain access to the hydraulic lines and
travel sensors.
5. Remove the hydraulic line retainers and remove
lines from the cylinder.
6. Remove the travel sensors from the cylinder (left
side only).
CONVERTIBLE TOP 23 - 495