Chrysler 2005 Crossfire SRT6 Service Manual page 3688

23 - 140 CONVERTIBLE TOP
9860 TRUNK LATCH ACTUATOR UNLOCK CONTROL CIRCUIT SHORT TO GROUND (CONTINUED)
• When Monitored: Continuously with the ignition on.
• Set Condition: When the Power Top Control Module (PTCM) senses high current flow on the Trunk
Latch Actuator Unlock Control circuit.
TRUNK LATCH ACTUATOR UNLOCK CONTROL CIRCUIT SHORT TO GROUND
TRUNK LATCH ASSEMBLY
POWER TOP CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
Trunk Latch Assembly
Turn the ignition off.
Disconnect the Trunk Latch Assembly C2 harness connector.
Note: Check connectors — Clean/repair as necessary.
Using a 12-volt test light connected to between the Trunk Latch Actua-
tor Lock Control circuit and the Trunk Latch Actuator Unlock Control
circuit at the Trunk Latch Assembly C2 harness connector.
With the DRB III , select Actuator Test and actuate the TRUNK
LATCH ACT UNLOCK.
Does the test light illuminate brightly when actuated?
Yes >> Replace the Trunk Latch Assembly.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 2
Possible Causes
ZH