Chrysler 2005 Crossfire SRT6 Service Manual page 4000

ZH
6. Disconnect the heated seat cushion from the 4-pin
connector.
7. Lift the seat cushion at the front and remove from
seat frame (2), then remove the two springs (1) on
the rear of the seat frame.
INSTALLATION
1. Install both springs (1) into the plate springs with
the narrow coils pointing downward at an angle
and insert into humps on cushion shell (2). Push
the seat cushion toward the rear below the seat
back.
2. Install the seat cushion at front and install to the
seat frame.
Note: Insert the connection leads into connector
with present leads.
3. Connect the leads for the heated seat cushion to
the 4-pin connector.
SEATS 23 - 439