Chrysler 2005 Crossfire SRT6 Service Manual page 3654

23 - 106 CONVERTIBLE TOP
9711 RIGHT ROTATION RELAY CONTROL CIRCUIT OPEN/SHORT TO B(+) (CONTINUED)
3.
PTCM
Turn the ignition off.
Measure the resistance between the Rotation Relay Ground circuit
and the Right Rotation Relay Control circuit at the Power Top Control
Module C2 harness connector.
Is the resistance between 60.0 - 90.0 ohms?
Yes >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL).
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 4
4.
Open Right Rotation Relay Control Circuit
With the ignition off.
Disconnect the Right Rotation Relay harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Right Rotation Relay Control circuit from
the Right Rotation Relay harness connector and the PTCM C2 har-
ness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the Right Rotation Relay Control circuit for an
open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL MODULES/
ZH