Chrysler 2005 Crossfire SRT6 Service Manual page 3718

23 - 170 CONVERTIBLE TOP
9909 REAR BOW SWITCH SENSE CIRCUIT OPEN (CONTINUED)
• When Monitored: Continuous with the ignition on.
• Set Condition: When the Power Top Control Module (PTCM) senses voltage on the Rear Bow Switch
Sense circuit when the convertible top is up.
OPEN REAR BOW SWITCH SENSE CIRCUIT
REAR BOW SWTICH
POWER TOP CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.
Diagnostic Test
1.
Read DTCs
Turn the ignition on.
With the DRBIII , read Current DTCs.
Are the Rear Bow Switch and the Tonneau Cover Switch Open
DTCs set?
Yes >> Check and repair the Switches common ground circuit for
a loose, damaged or corroded ground circuit.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 2
2.
Rear Bow Switch
Turn the ignition off.
Disconnect the Rear Bow Switch harness connector.
Note: Check connectors — Clean/repair as necessary.
Connect a fused jumper wire between the Rear Bow Switch Sense cir-
cuit and the Rear Bow Switch Ground circuit of the Rear Bow Switch
harness connector.
Turn the ignition on.
With DRBIII , select Input/Output Display and monitor the REAR BOW
SW SENSE.
Does the REAR BOW SW SENSE read "LOCKED"?
Yes >> Replace the Rear Bow Switch.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 3
Possible Causes
ZH