Chrysler 2005 Crossfire SRT6 Service Manual page 3612

23 - 64 CONVERTIBLE TOP
9620 MAIN CYLINDER TRAVEL SENSOR (BASE SIDE) +/- CIRCUIT OPEN/SHORT
TO GROUND (CONTINUED)
6.
Open Main Cylinder Travel Sensor (Base Side) (+) circuit
With the ignition on.
Measure the voltage of the Main Cylinder Travel Sensor (Base Side)
(+) circuit by backprobing from the Power Top Control Module C1 har-
ness connector.
Is the voltage above 10.0 volts?
Yes >> Repair the Main Cylinder Travel Sensor (Base Side) (+)
circuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Go To 7
7.
Main Cylinder Travel Sensor (Base Side) (+) Circuit Shorted to Ground
Turn the ignition off.
Disconnect the Power Top Control Module C1 harness connector.
Measure the resistance between ground and the Main Cylinder Travel
Sensor (Base Side) (+) circuit.
Is resistance below 100 kohms?
Yes >> Repair the Main Cylinder Travel Sensor (Base Side) (+)
circuit for a short to ground.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL)
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL MODULES/
ZH