Chrysler 2005 Crossfire SRT6 Service Manual page 3562

23 - 14 BODY - ELECTRICAL DIAGNOSTICS
REAR SPOILER DRIVER (UP) CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Continuous.
• Set Condition: The Body Control Module (BCM) reports a short to power, ground, or an open circuit failure on
the Rear Spoiler Driver (Up) circuit.
REAR SPOILER DRIVER (UP) CIRCUIT SHORTED TO B(+)
REAR SPOILER DRIVER (UP) CIRCUIT SHORTED TO GROUND
REAR SPOILER DRIVER (UP) CIRCUIT OPEN
BODY CONTROL MODULE
For a complete Rear Spoiler Circuit Diagram, (Refer to 23 - BODY - SCHEMATICS AND DIAGRAMS).
Diagnostic Test
1.
OPEN REAR SPOILER DRIVER (UP) CIRCUIT
Turn the ignition off.
Disconnect the BCM C4 harness connector.
Disconnect the Rear Spoiler Motor harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Rear Spoiler Driver (Up) circuit from the
BCM C4 harness connector to the Rear Spoiler Motor harness con-
nector.
Is the resistance below 5.0 ohms?
Yes >> Go to 2
No >> Repair the Rear Spoiler Driver (Up) circuit for an open.
Perform REAR SPOILER VERIFICATION TEST.
POSSIBLE CAUSES
ZH