Chrysler 2005 Crossfire SRT6 Service Manual page 4061

23 - 500 CONVERTIBLE TOP
15. Disconnect the hydraulic lines (4) from the cylin-
der (2).
16. Remove the travel sensors from the rear bow cyl-
inder (left side only).
17. Remove the upper and lower retainers (1 and 3)
and remove the cylinder from the top frame
assembly (right side shown, left side similar).
REMOVAL - CYLINDER TRAVEL SENSOR
Note: If a main cylinder or rear bow cylinder travel
sensor is faulty, all of the main and rear bow cyl-
inder travel sensors must be replaced.
1. Remove the plastic tie wrap (3) from the hydraulic
cylinder.
2. Rotate the hydraulic line (1) on the hydraulic cylin-
der in order to gain access to the travel sensor.
Note: The travel sensor is retained by a pressed
fit. To remove the travel sensor, grasp the sensor
and gently pry the sensor from the hydraulic cyl-
inder housing.
3. Remove the travel sensor (2) from the hydraulic
cylinder.
ZH