Chrysler 2005 Crossfire SRT6 Service Manual page 3611

ZH
9620 MAIN CYLINDER TRAVEL SENSOR (BASE SIDE) +/- CIRCUIT OPEN/SHORT
TO GROUND (CONTINUED)
4.
Open Main Cylinder Travel Sensor (Base Side) (-) Circuit
Turn the ignition off.
Disconnect the Power Top Control Module C1 harness connector.
Measure the resistance of the Main Cylinder Travel Sensor (Base
Side) (-) circuit from the Power Top Travel Sensors harness connector
to the Power Top Control Module C1 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 5
No >> Repair the Main Cylinder Travel Sensor (Base Side) (-) cir-
cuit for an open.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
5.
Main Cylinder Travel Sensor (Base Side) (-) Circuit Shorted to Ground
With the ignition off.
Measure the resistance between ground and the Main Cylinder Travel
Sensor (Base Side) (-) circuit.
Is resistance below 100 kohms?
Yes >> Repair the Main Cylinder Travel Sensor (Base Side) (-) cir-
cuit for a short to ground.
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
No >> Replace the Power Top Control Module.(Refer to 8 -
ELECTRICAL/ELECTRONIC
POWER TOP CONTROL MODULE - REMOVAL)
Perform POWER TOP CONTROL MODULE VERIFICA-
TION TEST.
CONTROL MODULES/
CONVERTIBLE TOP 23 - 63