Shock Absorber - Honda Hawk GT NT650 1988 Service Manual

Install the following:
- stop rubber onto the damper rod
- spring guide
- spring adjuster, set to the softest position
- dust seal
- lower spring seat
- spring with the tapered end upward
- upper spring seat
(1)
SPRING
Install the shock' absorber drain tube on the seat.
Make sure the tab of the seat is aligned with the groove of the
spring guide.
NOTE
• Make sure the spring adjuster is set to the softest position.
Set the shock absorber in the hydraulic press with the special
tool.
TOOL:
Shock absorber compressor attachment
07967-KE10000
Compress the spring until the stop ring can be installed, and in-
stall the stop ring.
REAR WHEEL/SUSPENSION
(2) SPRING GUIDE
~6'
LOWER JOINT
(1) SEAT
(2) ALIGN
(1 )
SHOCK ABSORBER
COMPRESSOR
I
ATTACHEMENT
13-17