Exhaust Pipe/Muffler - Honda SH300 2006 Manual

EXHAUST PIPE/MUFFLER

Remove the maintenance lid (page 3-4).
Remove the two special bolts and exhaust pipe pro-
tector.
Loosen the exhaust pipe band bolt.
Remove the two exhaust pipe joint nuts.
Remove the three bolts and exhaust pipe/muffler
then remove the gasket.
Separate the exhaust pipe and muffler, then remove
the gasket.
Installation is in the reverse order of removal.
When installing the
exhaust pipe/muf-
When removing the exhaust pipe stud bolts, tighten
fler, replace the
them to the specified torque.
gaskets with new
ones. TORQUE: 9 N·m (0.9 kgf·m, 6.6 lbf·ft)
Check that the exhaust pipe stud bolt protrusion
from the cylinder head is specified length as shown.
SPECIFIED LENGTH: 34 mm (1.3 in)
Tighten the exhaust pipe joint nuts, exhaust pipe
band bolt and muffler mounting bolts in the
sequence as shown.
TORQUE:
Exhaust pipe joint nut: 29 N·m (3.0 kgf·m, 21 lbf·ft)
Muffler mounting bolt: 49 N·m (5.0 kgf·m, 36 lbf·ft)
Exhaust pipe band bolt: 22 N·m (2.2 kgf·m, 16 lbf·ft)
After installation, inspect the exhaust system for
leaks.
BOLTS
Tightening procedure:
MUFFLER
SPECIAL BOLTS
BAND BOLT
GASKET
3
4, 5
FRAME/BODY PANELS/EXHAUST SYSTEM
PROTECTOR
EXHAUST PIPE
JOINT NUTS
2
1
6
GASKET
Stud bolt specified length:
34 mm (1.3 in)
3-15