Firmware (Program) Upload/Download (B044/B045/B046) - Gestetner B130 Service Manual

SERVICE PROGRAM
5.1.13 FIRMWARE (PROGRAM) UPLOAD/DOWNLOAD
(B044/B045/B046)
The program (firmware) for this machine is upgraded using a 4MB flash memory
card. The machine provides the following two SPs to support program porting and
upgrade:
• SP5-826: Uploads the program from the machine's flash ROM to a flash
memory card.
• SP5-827: Downloads the selected program from a flash memory card to the
machine's flash ROM.
Since the program size is only 2MB, it is possible to carry two different program
versions on a single card, and selectively download either one of these. If you wish
to carry two different programs on the same card, write one of these programs into
card address space 000000h to 1FFFFFh, and write the other one into address
space 200000h to 3FFFFFh.
Program Download (SP5-827)
This SP is effective only if you boot the machine from the flash memory card as
described below. If the download is unsuccessful, or if you decide that you do not
wish to start the download, please turn the machine off and back on before
resuming normal operation.
NOTE: Be sure to turn off the main switch before inserting or removing the flash
memory card. Installing or removing a card while the main switch is on may
damage the FCU.
1. Turn off the main switch.
2. Insert the flash memory card [A] into the card slot, with the card's "B" side
facing the rear of the machine.
B129 Series/B044 Series
CÓPIA NÃO CONTROLADA
5-96
CÓPIA NÃO CONTROLADA
[A]
B046M012.WMF
SM