Storm-Control Broadcast Level; Storm-Control Broadcast Rate - NETGEAR M6100 Series Reference Manual

no storm-control broadcast
Use this command to disable broadcast storm recovery mode for all interfaces (Global Config
mode) or one or more interfaces (Interface Config mode).
Format
no storm-control broadcast
Mode Global Config
Interface Config

storm-control broadcast level

Use this command to configure the broadcast storm recovery threshold for all interfaces
(Global Config mode) or one or more interfaces (Interface Config mode) as a percentage of
link speed and enable broadcast storm recovery. If the mode is enabled, broadcast storm
recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic is dropped. Therefore, the rate of broadcast traffic
is limited to the configured threshold. The threshold level can be in the range from 0–100.
The default is 5.
Default 5
Format
storm-control broadcast level threshold
Mode Global Config
Interface Config
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for all
interfaces (Global Config mode) or one or more interfaces (Interface Config mode) and
disables broadcast storm recovery.
Format
no storm-control broadcast level
Mode Global Config
Interface Config

storm-control broadcast rate

Use this command to configure the broadcast storm recovery threshold for all interfaces
(Global Config mode) or one or more interfaces (Interface Config mode) in packets per
second. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the
traffic is dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold.
The threshold rate can be in the range from 0–33554431. The default is 0.
M6100 Series Switches
Switching Commands
421