Storm-Control Broadcast Level (Global Config); Storm-Control Broadcast Rate (Global Config) - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Format
no storm-control broadcast
Mode Global Config

storm-control broadcast level (Global Config)

This command configures the broadcast storm recovery threshold for all interfaces as a percentage
of link speed and enables broadcast storm recovery. If the mode is enabled, broadcast storm
recovery is active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic will be dropped. Therefore, the rate of broadcast traffic
will be limited to the configured threshold.This command also enables broadcast storm recovery
mode for all interfaces.
Default 5
Format
storm-control broadcast level <0-100>
Mode Global Config
no storm-control broadcast level
This command sets the broadcast storm recovery threshold to the default value for all interfaces
and disables broadcast storm recovery.
Format
no storm-control broadcast level
Mode Global Config

storm-control broadcast rate (Global Config)

Use this command to configure the broadcast storm recovery threshold for all interfaces in packets
per second. If the mode is enabled, broadcast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured threshold, the traffic is
dropped. Therefore, the rate of broadcast traffic is limited to the configured threshold.
Default 0
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-81