Configure Storm Control Settings - NETGEAR S350 Series User Manual

S350 Series 8-Port Gigabit Ethernet Smart Managed Pro Switch Models GS308T and GS310TP
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 11.
Your web browser might display a security message, which you can ignore. For more
information, see Access the Local Browser Interface
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > Traffic Control > MAC Filter > MAC Filter Summary.
The following table describes the information displayed on the page.
Table 52. MAC Filter Summary information
Field
MAC Address
VLAN ID
Source Port Members
Destination Port Members

Configure Storm Control Settings

A broadcast storm is the result of an excessive number of broadcast messages
simultaneously transmitted across a network by a single port. Forwarded message
responses can overload network resources, cause the network to time out, or do both.
The switch measures the incoming packet rate per port for broadcast, multicast, unknown,
and unicast packets and discards packets if the rate exceeds the defined value. You enable
storm control per interface, by defining the packet type and the rate at which the packets are
transmitted.
Configure Global Storm Control Settings
The global storm control settings apply to all ports. After you configure the global settings,
you can specify storm control settings for one or more ports.
Description
The MAC address of the filter in the format XX:XX:XX:XX:XX:XX.
The VLAN ID used with the MAC address to fully identify packets you want filtered.
The ports to be used for filtering inbound packets.
The ports to be used for filtering outbound packets.
Manage Device Security
236
Change the Default IP Address of the
on page 19.