Dot1X Max-Req; Dot1X Port-Control - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

11.1.7 dot1x max-req

This command sets the maximum number of times the authenticator state machine on this
port will transmit an EAPOL EAP Request/Identity frame before timing out the
supplicant. The
Default
Format
Mode
11.1.7.1 no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this
port will transmit an EAPOL EAP Request/Identity frame before timing out the
supplicant.
Format
Mode

11.1.8 dot1x port-control

This command sets the authentication mode to be used on the specified port. The control
mode may be one of the following.
force-unauthorized: The authenticator PAE unconditionally sets the controlled port to
unauthorized.
force-authorized: The authenticator PAE unconditionally sets the controlled port to
authorized.
auto: The authenticator PAE sets the controlled port mode to reflect the outcome of the
authentication exchanges between the supplicant, authenticator and the authentication
server.
Default
Format
Mode
11-4
value must be in the range 1 - 10.
<count>
2
dot1x max-req <count>
Interface Config
no dot1x max-req
Interface Config
auto
dot1x port-control {force-unauthorized | force-
authorized | auto}
Interface Config
v3.0, January 2008
Port-Based Access and Authentication Commands