Dot1X Max-Req; Dot1X Max-Users - NETGEAR GSM7228PS Cli Manual

dot1x max-req

This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The <count>
value must be in the range 1 - 10.
Default 2
Format
dot1x max-req <count>
Mode Interface Config
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant.
Format
no dot1x max-req
Mode Interface Config

dot1x max-users

Use this command to set the maximum number of clients supported on the port when MAC-based
dot1x authentication is enabled on the port. The maximum users supported per port is dependent
on the product. The <count> value is in the range 1 - 16.
Default 16
Format
dot1x max-users <count>
Mode Interface Config
no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
Format
no dot1x max-req
Mode Interface Config
Switching Commands
Managed Switch CLI Manual, Release 8.0.3
v1.0, July 2010
3-66