Set Gmrp Interfacemode; Show Gmrp Configuration - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches

8.3.2 set gmrp interfacemode

This command enables GARP Multicast Registration Protocol. If an interface which has
GARP enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
GARP functionality is disabled on that interface. GARP functionality is subsequently re-
enabled if routing is disabled and port-channel (LAG) membership is removed from an
interface that has GARP enabled.
Default
Format
Modes
8.3.2.1 no set gmrp interfacemode
This command disables GARP Multicast Registration Protocol. If an interface which has
GARP enabled is enabled for routing or is enlisted as a member of a port-channel (LAG),
GARP functionality is disabled. GARP functionality is subsequently re-enabled if routing
is disabled and port-channel (LAG) membership is removed from an interface that has
GARP enabled.
Format
Modes

8.3.3 show gmrp configuration

This command displays GARP information for one or all interfaces.
Format
Modes
Interface
Join Timer
GARP, GVRP, and GMRP Commands
disabled
set gmrp interfacemode
Interface Config
Global Config
no set gmrp interfacemode
Interface Config
Global Config
show gmrp configuration {<unit/slot/port> | all}
Privileged EXEC
User EXEC
This displays the
unit/slot/port
the table describes.
Specifies the interval between the transmission of GARP
PDUs registering (or re-registering) membership for an
attribute. Current attributes are a VLAN or multicast group.
There is an instance of this timer on a per-port, per-GARP
participant basis. Permissible values are 10 to 100 centisec-
onds (0.1 to 1.0 seconds). The factory default is 20 centisec-
v1.0, October 2008
of the interface that this row in
8-7