Show Snmpcommunity; Show Snmptrap - NETGEAR M6100 Series Reference Manual

show snmpcommunity

This command displays SNMP community information. Six communities are supported. You
can add, change, or delete communities. You do not need to reset the switch for changes to
take effect.
The SNMP agent of the switch complies with SNMP Versions 1, 2, and 3. For more
information about the SNMP specification, see the SNMP RFCs. The SNMP agent sends
traps through TCP/IP to an external SNMP manager based on the SNMP configuration (the
trap receiver and other SNMP community parameters).
Format
show snmpcommunity
Mode Privileged EXEC
Term Definition
SNMP The community string to which this entry grants access. A valid entry is a case-sensitive alphanumeric
Community string of up to 16 characters. Each row of this table must contain a unique community name.
Name
Client IP An IP address (or portion thereof) from which this device will accept SNMP packets with the
Address associated community. The requesting entity's IP address is ANDed with the Subnet Mask before
being compared to the IP address. Note: If the Subnet Mask is set to 0.0.0.0, an IP address of 0.0.0.0
matches all IP addresses. The default value is 0.0.0.0.
Client IP Mask A mask to be ANDed with the requesting entity's IP address before comparison with IP address. If the
result matches with IP address then the address is an authenticated IP address. For example, if the IP
address = 9.47.128.0 and the corresponding Subnet Mask = 255.255.255.0 a range of incoming IP
addresses would match, i.e. the incoming IP address could equal 9.47.128.0 - 9.47.128.255. The
default value is 0.0.0.0.
Access Mode The access level for this community string.
Status The status of this community access entry.

show snmptrap

This command displays SNMP trap receivers. Trap messages are sent across a network to
an SNMP network manager. These messages alert the manager to events occurring within
the switch or on the network. Six trap receivers are simultaneously supported.
Format
show snmptrap
Mode Privileged EXEC
Term Definition
SNMP Trap The community string of the SNMP trap packet sent to the trap manager. The string is case-sensitive
Name and can be up to 16 alphanumeric characters.
IP Address The IPv4 address to receive SNMP traps from this device.
IPv6 Address The IPv6 address to receive SNMP traps from this device.
M6100 Series Switches
Management Commands
117