Show Snmptrap; Show Trapflags - NETGEAR GSM7224R - ProSafe Switch Cli Reference Manual

Command Line Interface Reference for the ProSafe 7200R Series Layer-2 Switches with Static
Client IP Mask
Access Mode
Status

10.2.2 show snmptrap

This command displays SNMP trap receivers. Trap messages are sent across a network to
an SNMP Network Manager. These messages alert the manager to events occurring within
the switch or on the network. Six trap receivers are simultaneously supported.
Format
Mode
SNMP Trap Name
IP Address
Status

10.2.3 show trapflags

This command displays trap conditions. Configure which traps the switch should generate
by enabling or disabling the trap condition. If a trap condition is enabled and the condition
is detected, the SNMP agent on the switch sends the trap to all enabled trap receivers. You
do not have to reset the switch to implement the changes. Cold and warm start traps are
always generated and cannot be disabled.
Format
Mode
SNMP Commands
Subnet Mask is set to 0.0.0.0, an IP Address of 0.0.0.0
matches all IP addresses. The default value is 0.0.0.0
A mask to be ANDed with the requesting entity's IP address
before comparison with IP Address. If the result matches
with IP Address then the address is an authenticated IP
address. For example, if the IP Address = 9.47.128.0 and the
corresponding Subnet Mask = 255.255.255.0 a range of
incoming IP addresses would match, i.e. the incoming IP
Address could equal 9.47.128.0 - 9.47.128.255. The default
value is 0.0.0.0
The access level for this community string.
The status of this community access entry.
show snmptrap
Privileged EXEC
The community string of the SNMP trap packet sent to the
trap manager. The string is case sensitive and can be up to 16
alphanumeric characters.
The IP address to receive SNMP traps from this device.
Indicates the receiver's status (enabled or disabled).
show trapflags
Privileged EXEC
v1.0, November 2007
10-11