Mode Dvlan-Tunnel; Show Dot1Q-Tunnel - NETGEAR ProSafe GSM7228PS Cli Manual

mode dvlan-tunnel

Use this command to enable Double VLAN Tunneling on the specified interface.
Note: When you use the mode dvlan-tunnel command on an interface, it becomes
a service provider port. Ports that do not have double VLAN tunneling enabled are
customer ports.
Default disabled
Format
mode dvlan-tunnel
Mode Interface Config
no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default,
Double VLAN Tunneling is disabled.
Format
no mode dvlan-tunnel
Mode Interface Config

show dot1q-tunnel

Use this command without the optional parameters to display all interfaces enabled for Double
VLAN Tunneling. Use the optional parameters to display detailed information about Double
VLAN Tunneling for the specified interface or all interfaces.
Format
show dot1q-tunnel [interface {<unit/slot/port> | all}]
Mode • Privileged EXEC
• User EXEC
Term Definition
Interface Valid slot and port number separated by forward slashes.
Mode The administrative mode through which Double VLAN Tunneling can be enabled or
disabled. The default value for this field is disabled.
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-46