Traceroute Ipv6 - NETGEAR S3300 User Manual

• IP Address — The source is an IP address that you specify using when sending the
Echo request packets. This field is shown when IP Address is selected as the source
option.
• Interface — The interface to use when sending the Echo request packets. This field is
shown when Interface is selected as the source option.
Note: Values configured in the fields above are not saved to the switch. As a
result, refreshing the page sets these fields to the default values.
11. Click Apply to sends a traceroute request to the specified IP address or hostname. The
results are displayed below the configurable data in the TraceRoute Results area.
12. Click Cancel to cancel the operation on the screen and reset the data on the screen to the
latest value of the switch.

Traceroute IPv6

Use this screen to tell the switch to send a TraceRoute request to a specified IPv6 address or
Hostname. You can use this to discover the paths that an IPv6 packet takes to a remote
destination. Once you click the Apply button, the switch will send a traceroute and the results
will be displayed below the configurable data.
If a reply to the traceroute is received, you will see:
1 a:b:c:d:e:f:g 9869 usec 9775 usec 10584 usec
2 0:0:0:0:0:0:0:0 0 usec * 0 usec * 0 usec *
Hop Count = w Last TTL = z Test attempt = x Test Success = y.

To trace a route to an IPv6 address or host:
1. Select Maintenance > Troubleshooting > Traceroute IPv6.
S3300 Smart Managed Pro Switch
Maintenance
310