Show Sntp Server - NETGEAR GSM7248R Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7200RS Series Layer-2 Stackable Switches
Client Supported
Modes
SNTP Version
Port
Client Mode
Poll Interval
Poll Timeout
Poll Retry

4.3.11 show sntp server

This command is used to display SNTP server settings and configured servers.
Format
Mode
Server IP
Address
Server Type
Server Stratum
Server Reference
ID
Server Mode
Server Max
Entries
Server Current
Entries
For each configured server:
IP Address
Address Type
Priority
Version
Port and System Setup Commands
Supported SNTP Modes (Broadcast, Unicast, or Multicast).
The highest SNTP version the client supports
SNTP Client Port
Configured SNTP Client Mode
Poll interval value for SNTP clients in seconds as a power of
two.
Poll timeout value in seconds for SNTP clients.
Poll retry value for SNTP clients.
show sntp server
Privileged EXEC
IP Address of configured SNTP Server
Address Type of Server.
Claimed stratum of the server for the last received valid
packet.
Reference clock identifier of the server for the last received
valid packet.
SNTP Server mode.
Total number of SNTP Servers allowed.
Total number of SNTP configured.
IP Address of configured SNTP Server.
Address Type of configured SNTP server.
IP priority type of the configured server.
SNTP Version number of the server. The protocol version
used to query the server in unicast mode.
v1.0, October 2008
4-15