Show Router Ospf Info; Config Router Id - NETGEAR GSM7324 Reference Manual

7000 Series L3 Managed Switch Reference Manual for Software v1.0

show router ospf info

This command displays information relevant to the OSPF router. This command takes no options.
Format
Router ID
OSPF Admin Mode
ASBR Mode
The information below will only be displayed if OSPF is enabled.
ABR Status
Exit Overflow Interval
External LSA count
External LSA Checksum
New LSAs Originated
LSAs Received
External LSDB Limit

config router id

This command sets a 4-digit dotted-decimal number uniquely identifying the router. To ensure
uniqueness, it defaults to the value of the switch's management IP address. If this value is not
configured, then the value of any active router interface IP address is used.
Format
8-8
show router ospf info
Is a 32 bit integer in dotted decimal format identifying the router,
about which information is displayed. This is a configured value.
The administrative mode of OSPF in the router. This is a config-
ured value.
Reflects whether the ASBR mode is enabled or disabled. Enable
implies that the router is an autonomous system border router.
This is a configured value.
Reflects the whether or not the router is an OSPF Area Border
Router.
The number of seconds that, after entering OverflowState, a
router will attempt to leave OverflowState.
The number of external (LS type 5) link-state advertisements in
the link-state database.
A number which represents the sum of the LS checksums of
external link-state advertisements contained in the link-state data-
base.
The number of new link-state advertisements that have been orig-
inated.
The number of link-state advertisements received determined to
be new instantiations.
The maximum number of non-default AS-external-LSAs
entries that can be stored in the link-state database.
config router id <routerid>
May 30, 2003 Beta Draft
Routing Commands