Ip Vrrp Mode; Ip Vrrp Ip - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
14.5.2 ip vrrp
This command enables the administrative mode of VRRP in the router. This command
also designates the configured virtual router IP address as a secondary IP address on an
interface.
Default
Format
Mode
14.5.2.1 no ip vrrp
This command disables the default administrative mode of VRRP in the router.
Format
Mode

14.5.3 ip vrrp mode

This command enables the virtual router configured on the specified interface. Enabling
the status field starts a virtual router. The parameter
has an integer value ranging from 1 to 255.
Default
Format
Mode
14.5.3.1 no ip vrrp mode
This command disables the virtual router configured on the specified interface. Disabling
the status field stops a virtual router.
Format
Mode

14.5.4 ip vrrp ip

This command sets the virtual router ipaddress value for an interface. The value for
is the IP Address which is to be configured on that interface for VRRP. The
<ipaddr>
parameter
<vrID>
Default
Format
14-24
enabled
ip vrrp <vrid> <ipaddress> [secondary]
Global Config
no ip vrrp
Global Config
disabled
ip vrrp <vrID> mode
Interface Config
no ip vrrp <vrID> mode
Interface Config
is the virtual router ID which has an integer value range from 1 to 255.
none
ip vrrp <vrID> ip <ipaddr>
v1.0, December 2005
is the virtual router ID which
<vrID>
Routing Commands