Ip Vrrp Ip; Ip Vrrp Authentication - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

ip vrrp ip

This command sets the virtual router IP address value for an interface. The value for <ipaddr> is
the IP address which is to be configured on that interface for VRRP. The parameter <vrid> is the
virtual router ID which has an integer value range from 1 to 255. You can use the optional
[secondary] parameter to designate the IP address as a secondary IP address.
Default none
Format
ip vrrp <vrid> ip <ipaddr> [secondary]
Mode Interface Config
no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value from the
interface. To delete the primary IP address, you must delete the virtual router on the interface.
Format
no ip vrrp <vrid> <ipaddress> secondary
Mode Interface Config

ip vrrp authentication

This command sets the authorization details value for the virtual router configured on a specified
interface. The parameter {none | simple} specifies the authorization type for virtual router
configured on the specified interface. The parameter [key] is optional, it is only required when
authorization type is simple text password. The parameter <vrid> is the virtual router ID which
has an integer value ranges from 1 to 255.
Default no authorization
Format
ip vrrp <vrid> authentication {none | simple <key>}
Mode Interface Config
no ip vrrp authentication
This command sets the default authorization details value for the virtual router configured on a
specified interface.
Format
no ip vrrp <vrid> authentication
Mode Interface Config
Routing Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
4-27