No Ip Route Default; Ip Route Distance; No Ip Route Distance; Ip Forwarding - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Format
Mode

no ip route default

This command deletes all configured default routes. If the optional <nextHopRtr> parameter is
designated, the specific next hop is deleted from the configured default route and if the optional
preference value is designated, the preference of the configured default route is reset to its default.
Format
Mode

ip route distance

This command sets the default distance for static routes. Lower route preference values are
preferred when determining the best route. The "ip route" and "ip route default" commands allow
you to optionally set the distance of an individual static route. The default distance is used when no
distance is specified in these commands. Changing the default distance does not update the
distance of existing static routes, even if they were assigned the original default distance. The new
default distance will only be applied to static routes created after invoking the "ip route distance"
command.
Default
Format
Mode

no ip route distance

This command sets the default static route preference value in the router. Lower route preference
values are preferred when determining the best route.
Format
Mode

ip forwarding

This command enables forwarding of IP frames.
Default
Routing Commands
ip route default <nextHopRtr> [<preference>]
Global Config
no ip route default [{<nextHopRtr> | <preference>}]
Global Config
1
ip route distance <1-255>
Global Config
no ip route distance
Global Config
enabled
202-10088-01, March 2005
10-9