Ip Route Default; Ip Route Distance - NETGEAR ProSafe GSM7224P User Manual

• Confirm that the associated link is also up.
Default
preference—1
Format
ip route <ipaddr> <subnetmask> [<nexthopip> | Null0] [<preference>]
Mode
Global Config
no ip route
This command deletes a single next hop to a destination static route. If you use the
<nexthopip> parameter, the next hop is deleted. If you use the <preference> value, the
preference value of the static route is reset to its default.
Format
no ip route <ipaddr> <subnetmask> [{<nexthopip> [<preference>] |
Null0}]
Mode
Global Config

ip route default

This command configures the default route. The value for <nexthopip> is a valid IP
address of the next hop router. The <preference> is an integer value from 1 to 255. A
route with a preference of 255 cannot be used to forward traffic.
Default
preference—1
Format
ip route default <nexthopip> [<preference>]
Mode
Global Config
no ip route default
This command deletes all configured default routes. If the optional <nexthopip> parameter
is designated, the specific next hop is deleted from the configured default route and if the
optional preference value is designated, the preference of the configured default route is
reset to its default.
Format
no ip route default [{<nexthopip> | <preference>}]
Mode
Global Config

ip route distance

This command sets the default distance (preference) for static routes. Lower route distance
values are preferred when determining the best route. The ip route and ip route
default commands allow you to optionally set the distance (preference) of an individual
static route. The default distance is used when no distance is specified in these commands.
Changing the default distance does not update the distance of existing static routes, even if
ProSafe Managed Switch
Routing Commands
241