Port-Security Mac-Address Move; Show Port-Security; Show Port-Security Dynamic - NETGEAR ProSafe GSM7228PS Cli Manual

port-security mac-address move

This command converts dynamically locked MAC addresses to statically locked addresses.
Format
port-security mac-address move
Mode Interface Config

show port-security

This command displays the port-security settings. If you do not use a parameter, the command
displays the settings for the entire system. Use the optional parameters to display the settings on a
specific interface or on all interfaces.
Format
show port-security [{<unit/slot/port> | all}]
Mode Privileged EXEC
Term Definition
Admin Mode Port Locking mode for the entire system. This field displays if you do not supply any
parameters.
For each interface, or for the interface you specify, the following information appears:
Term Definition
Admin Mode Port Locking mode for the Interface.
Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit Maximum statically allocated MAC Addresses.
Violation Trap Whether violation traps are enabled.
Mode

show port-security dynamic

This command displays the dynamically locked MAC addresses for the port.
Format
show port-security dynamic <unit/slot/port>
Mode Privileged EXEC
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
v1.0, May 2010
3-156