Set Mld Querier Timer Expiry; Set Mld Querier Election Participate; Show Mldsnooping Querier - NETGEAR M6100 Series Reference Manual

set mld querier timer expiry

Use this command to set the MLD querier timer expiration period. It is the period in seconds,
from 60–300 seconds, that the switch remains in non-querier mode after it has discovered a
multicast querier in the network.
Default 60 seconds
Format
set mld querier timer expiry seconds
Mode Global Config
no set mld querier timer expiry
Use this command to set the MLD querier timer expiration period to its default value.
Format
no set mld querier timer expiry
Mode Global Config

set mld querier election participate

Use this command to enable the Snooping Querier to participate in the Querier Election
process when it discovers the presence of another Querier in the VLAN. When this mode is
enabled, if the Snooping Querier finds that the other Querier's source address is better (less)
than the Snooping Querier's address, it stops sending periodic queries. If the Snooping
Querier wins the election, then it will continue sending periodic queries.
Default disabled
Format
set mld querier election participate
Mode VLAN Config
no set mld querier election participate
Use this command to set the snooping querier not to participate in querier election but go into
a non-querier mode as soon as it discovers the presence of another querier in the same
VLAN.
Format
no set mld querier election participate
Mode VLAN Config

show mldsnooping querier

Use this command to display MLD Snooping Querier information. Configured information is
displayed whether or not MLD Snooping Querier is enabled.
Format
show mldsnooping querier [detail | vlan vlan-id]
Mode Privileged EXEC
M6100 Series Switches
Switching Commands
535