Configure Mld Snooping Querier - NETGEAR XS708T User Manual

XS708T, XS712Tv2, and XS716T Smart Managed Pro Switch User Manual

Configure MLD Snooping Querier

You can configure the parameters for an MLD snooping querier. Only a user with read/write
access privileges can change the settings on this page.

To configure an MLD snooping querier:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Switch on page 10.
The login window opens.
4. Enter the switch's password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> Multicast > MLD Snooping > Querier Configuration.
6. Configure the following settings:
• Querier Admin Mode. Enable or disable MLD snooping for the switch. The default is
Disable.
• Querier Address. Enter an IP address. This specifies the snooping querier address
to be used as the source address in periodic MLD queries. This address is used when
no address is configured on the VLAN on which a query is being sent. The supported
IPv6 formats are x:x:x:x:x:x:x:x and x::x.
• MLD Version. Specify the MLD protocol version used in periodic MLD queries.
• Query Interval(secs). Specify the time interval in seconds between periodic queries
sent by the snooping querier. The query interval must be a value in the range of 1 to
1800. The default value is 60.
Change the Default IP Address of the
Configure Switching
186