Clear Ip Arp Inspection Statistics; Show Ip Arp Inspection Interfaces - NETGEAR ProSafe GSM7228PS Cli Manual

10 11 1
20 1 0

clear ip arp inspection statistics

Use this command to reset the statistics for Dynamic ARP Inspection on all VLANs.
Default
none
Format
clear ip arp inspection statistics
Mode Privileged EXEC

show ip arp inspection interfaces

Use this command to display the Dynamic ARP Inspection configuration on all the DAI-enabled
interfaces. An interface is said to be enabled for DAI if at least one VLAN, that the interface is a
member of, is enabled for DAI. Given a unit/slot/port interface argument, the command displays
the values for that interface whether the interface is enabled for DAI or not.
Format
show ip arp inspection interfaces [unit/slot/port]
Mode • Privileged EXEC
• User EXEC
Term Definition
Interface The interface ID for each displayed row.
Trust State Whether the interface is trusted or untrusted for DAI.
Rate Limit The configured rate limit value in packets per second.
Burst Interval The configured burst interval value in seconds.
Example: The following shows example CLI display output for the command.
(Switch) #show ip arp inspection interfaces
Interface Trust State
---------------
0/1
Switching Commands
ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3
65
8
Rate Limit
(pps)
----------- ----------
Untrusted
v1.0, May 2010
25 1
2 0
Burst Interval
(seconds)
---------------
15
1 0
1 1
1
3-137