Tone And Digit Switch Cards - Avaya Nortel Communication Server 1000 Reference

Tone and digit switch cards

Testing tone and digit switch cards
Use this procedure to test a tone and digit switch (TDS) card or to test the TDS function of an
NT8D17 Conference/TDS card.
1. Log into the system: LOGI (password)
2. Obtain a list of terminal numbers (TNs) for disabled TDS cards: LD 34 STAD
3. If the TDS loop to be tested is disabled, enable it.
4. Test the TDS loop: TDS loop
5. End the session in LD 34: ****
6. Using a maintenance telephone, log into the system.
7. From the maintenance telephone, enter: LD#34##
8. Exit LD 34 from the maintenance telephone: ****
Table 13: TDS tone tests
Input command
BSY#loop##
Circuit Card Reference
For an NT8D17 Conference/TDS card, enter: ENLX loop (The TDS/MFS loop is
the even loop of the conference/TDS loop pair.)
Note:
The conference/TDS card is not enabled automatically when it is inserted. You
must enable the card with the command ENLX. (This command is used in LD 34
and LD 46 to address even loops and in LD 38 to address odd loops.) Enabling
the loops with the command ENLL does not enable the hardware for the card.
For other than an NT8D17 Conference/TDS card, enter: ENLL loop
If the system response is other than OK, see Software Input/Output Reference —
Administration (NN43001-611) to analyze the messages.
See "Communicating with the Meridian 1" in Software Input/Output Reference —
Administration (NN43001-611) for details on accessing the system using a
maintenance telephone.
To test outpulsers and channels for the TDS loop, see
page 85 for a sample of the input commands used with the maintenance
telephone. See Software Input/Output Reference — Administration (NN43001-611)
for all tones that can be tested.
Dial pad
equivalent
279#loop## Provides busy tone from TDS loop specified.
Tone and digit switch cards
Table 13: TDS tone tests
Description
on
July 2011 85