Replacing An M320 Sib; Removing An M320 Sib; Handle; Figure 88: Removing A Pc Card - Juniper M320 Hardware Manual

M320 Router Hardware Guide

Figure 88: Removing a PC Card

Related
Documentation

Replacing an M320 SIB

Removing an M320 SIB

172
M320 Host Subsystem Description on page 18
M320 Routing Engine Description on page 19
Maintaining the M320 Host Subsystem on page 111
M320 Chassis Description on page 6
Preventing Electrostatic Discharge Damage to an M320 Router on page 214
Removing an M320 SIB on page 172
Installing an M320 SIB on page 173
Two to four SIBs are installed in the router. The SIBs are located in the rear of the chassis
in the slots marked through
SIB0
SIB weighs approximately 4 lb (1.8 kg).
To remove a SIB (see Figure 89 on page 173):
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Press the online/offline button on the SIB faceplate. Press and hold down the button
3.
until the green OK LED goes out (about 5 seconds).
Loosen the captive screws (using a Phillips (+) screwdriver, number 2) on the ejector
4.
handles on each side of the SIB faceplate.
. SIBs are hot-insertable and hot-removable. Each
SIB3
Copyright © 2010, Juniper Networks, Inc.