Figure 91: Ethernet Cable Connector; Installing A Tx Matrix Control Plane Cable; Replacing A Tx Matrix Management Ethernet Cable - Juniper TX MATRIX Hardware Manual

Installing a TX Matrix Control Plane Cable

Related
Documentation

Replacing a TX Matrix Management Ethernet Cable

Copyright © 2010, Juniper Networks, Inc.
Press the tab on the cable connector installed in the TX-CIP port and pull the connector
2.
straight out of the port. Figure 91 on page 231 shows the connector. The control plane
ports on the TX-CIP are labeled
NOTE: The RJ-45 ports labeled
reserved for future use.
Disconnect the cable plugged into the port labeled
3.
To install a control plane cable:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Plug one end of the replacement cable into the appropriate TX-CIP port.
2.
Plug the other end of the cable into the port labeled
3.
Dress the cable appropriately.
4.
TX Matrix Cables Overview on page 49
TX Matrix Connector Interface Panel (TX-CIP) Overview on page 38
TX Matrix Preventing Electrostatic Discharge Damage on page 298
The port on the TX-CIP accepts Ethernet cables with an RJ-45 connector.
ETHERNET

Figure 91: Ethernet Cable Connector

Chapter 24: Replacing TX Matrix Hardware Components
through .
LCC0 LCC3
LCC4 through LCC7
on the corresponding T-CB.
CIP
on the corresponding T-CB.
CIP
on a TX-CIP are
231